smartkontrols DHW History

Software Release History	DHW Controller with 3 x Triac Outputs
	DHW / DIN/ 3T

Software Release Document for:	DHW / DIN / 3T	DHW / DIN / AOP
PROM file header:	DHWD	DHWA (special order)

Software Version	Release Date	Further Information	Notes
4e1	16/03/06	Feature Notes Configuration Tables Wiring 3T Hardware 3T	pre release with pasturisation
4d1	20/10/04	Feature Notes Configuration Tables Wiring 3T Hardware 3T	pre release with pasturisation
4c4	25/11/02	Feature Notes Configuration Tables Wiring 3T Hardware 3T	correct calibration routine
4c3	12/11/02	Feature Notes Configuration Tables Wiring 3T Hardware 3T	correct limit at which Maximum Temperature routine will be active was SPMX>50 now corrected to SPMX>5
4c2	24/10/01	Feature Notes Configuration Tables Wiring 3T Hardware 3T	add USEB USE Boiler Flow temperature configuration parameter
4c1	11/10/00	Feature Notes Configuration Tables Wiring 3T Hardware 3T	add universal manual code add self test code add automatic calibration of sensors in test mode add maximum water temperature limit add output controlled by Occupancy if no valid sensor reading add software switch to select potentiometer option add Pump Alarm add input mode for selection of external input options add input status monitoring
4a4 config tables	02/02/99 issue notes	0006/0001 J12	add support for HAND mode from Doorway
4a3 config tables	16/12/98	0006/0001 J12	send CT setpoint of zero when there is no demand, needed to make DHW priority work correctly
4a2	06/10/98	0006/0001 J12	correct further problem with STOP alarm
4a1 config tables	05/10/98 issue notes	0006/0001 J12	add dual domain support changes to STOP alarm
3c2	20/05/98 issue notes	0006/0001G	add support for linking own occupation state to another occupation destination add automatic reset if no network variables are updated for 10 minutes, monitor number of resets on C84
3c1 config tables	15/04/98 issue notes	0006/0001G	major update to issue 3 code includes new slave modes, degree F mods, configurable plots, universal driver
2p	09/11/97	B	correct operation when being used with BLRDM add plus/minus start times add extend_hours default 2
2o	26/10/96	B	add valve mode 2 to allow shuting down drivers if electric heating enabled use VT temperature from Boiler if heat_source set to 0 send occupied bit to actuators
2n	24/10/97	B	correct scaling of sensor 1 and 2
2m	14/01/96	B	add support for supervisor variables as config parameters issue notes

ENER-G Controls

ENER-G House
Daniel Adamson Road
Salford
Manchester
M5 2DT

phone 0161 7457450
fax 0161 7457457

www.energ.com
www.seachange.co.uk
www.smartkontrols.co.uk